24/7 Emergency Garage Door Repairs · Residential & Commercial · Free Quotes

Perth Garage Door Specialists

Garage Door Motor & Opener Repairs in Perth

A garage door motor is a small machine asked to move a very large object several times a day for fifteen years, and most of the faults we are called to are not the motor's fault at all. A door that has gone stiff, a spring losing tension, or a guide full of sand all make the motor work harder until it trips, and replacing the motor without fixing the door just buys a more expensive version of the same failure. SwiftRoll diagnoses the whole system before quoting a motor: we check the door's balance by hand first, then the motor's force and travel settings, the safety beams, the drive — chain, belt or direct — and the board. Where the motor genuinely is finished we replace it with a unit matched to your door's weight and use, and we set it up properly rather than leaving it on factory defaults.

  • We test the door by hand before we quote you a motor — most 'motor faults' are not
  • Merlin, Centurion, B&D, ATA, Chamberlain, Avanti, Superlift and Grifco all serviced
  • Capacitors, boards, gears, chains and beams carried as repairable items, not upsells
  • Battery backup fitted as standard on hills and outer-metro properties where outages are real
  • Every install fully set up and safety-tested, never left on factory defaults

Get a Free Quote

Tell us what's happened — we'll call you straight back.

Add a message (optional)

No obligation · Free on-site quote · 24/7 emergency

What's included

What our motors & openers covers

Motors that hum and do nothing, run and stop, or died in a storm. Here's what we handle across Perth:

  • Motors that hum, click or do nothing at all
  • Doors that stop part-way or reverse unexpectedly
  • Burnt-out capacitors, boards and gearboxes
  • Stripped drive gears, sprockets and worn chains or belts
  • Travel limit and force setting recalibration
  • Safety beam alignment, replacement and wiring faults
  • Storm and power-surge damage
  • Battery backup fitting and battery replacement
  • Manual release cords, catches and re-engagement
  • Motor replacement matched to door weight and duty cycle
  • Commercial and high-cycle motors, including Grifco
  • Smart and WiFi-enabled motor upgrades
Garage door motor head opened for diagnosis, showing the drive gear and control board

How it works

What to expect when you call

1

Check the door before the motor

We disconnect the motor and run the door by hand. If it is heavy, sticky or will not stay put half open, the problem is the door and a new motor would simply fail sooner. This one step saves customers more money than anything else we do.

2

Diagnose the unit properly

Power in, capacitor, board, drive, limits, force settings and safety beams — tested in order. Perth's summer storms and afternoon power fluctuations kill more boards and capacitors here than mechanical wear does.

3

Repair, or replace with the right size

Capacitors, boards, gears, chains, belts and beams are all repairable items and we carry the common ones. Where the motor is genuinely done, we size the replacement to the door's actual weight and how often it runs — not to whatever is cheapest on the van.

4

Set it up, not just plug it in

Travel limits, force limits, auto-reverse, beam alignment, remotes paired and the manual release demonstrated. A motor left on factory defaults is the single most common cause of a door that reverses for no apparent reason.

Where we work

Motors & Openers in 93 Perth suburbs

We provide motors & openers right across the Perth metro area. These are the suburbs with a dedicated local page for it — find yours for the detail and response time:

Trusted locally

Motors & Openers — what customers say

Door started reversing about a foot off the ground and I'd convinced myself the motor was cooked. Turned out to be the safety beam plus a channel full of sand. He cleared it, realigned the beam, reset the limits and showed me what to look for. I'd been quoted a new motor elsewhere.
Marcus T. Applecross
Motor was humming and doing nothing. First thing he did was disconnect it and lift the door by hand — dead weight, so it was never the motor at all. Fixed the spring, left the motor alone, and told me not to replace something that wasn't broken.
Julia C. Nedlands
Storm took out our motor board. Replaced the board rather than the whole unit, wrote up the fault so I could claim it, and fitted a battery backup while he was there because we lose power up here fairly often.
Wei Z. Kalamunda

Swipe to see more →

Other garage door services

Free on-site quote

Need motors & openers in Perth?

Our technicians run right across the Perth metro area and reach most emergency callouts in around 60 to 90 minutes, with the springs, rollers, motors and panels on board to finish most repairs in one visit. Call now or request a free quote — no obligation, no surprises.

Good to know

Motors & Openers FAQs

My motor hums but the door doesn't move. What is that?

A hum with no movement usually means the motor is getting power but cannot turn the load. The three common causes are a failed capacitor, a stripped drive gear, or a door that has become too heavy for the motor because a spring has gone. The third is the important one to rule out first, because fitting a new motor to a door with a broken spring simply destroys the new motor too. We check the door by hand before anything else.

Is it worth repairing an old motor or should I replace it?

A capacitor, a board, a set of gears or a chain are all sensible repairs on a unit that is otherwise sound, and we carry the common ones. Where the housing is cracked, the gearbox is worn through, or the unit is old enough that no parts are available, replacement is the honest answer. We tell you which one you have and we do not pretend a repairable motor is finished.

Do I need an electrician to install a garage door motor in WA?

It depends on the connection, and this is worth knowing because it is frequently misrepresented. Plugging a modern motor into an existing power point in the garage is not electrical installation work and does not need a licensed electrical contractor. Adding a new power point, or hard-wiring a motor into the circuit, is electrical installation work under the Electricity (Licensing) Regulations, and must be done by a licensed electrical contractor with a Certificate of Compliance. We tell you which one your garage needs, and we do not charge you for a sparky you do not require.

My motor died after a storm. Is that covered by anything?

Surge damage to a garage door motor is often claimable on home contents or building insurance depending on your policy, and we can provide a written report of the fault for a claim. Practically, the fix is usually a board or a capacitor rather than the whole unit. If your garage loses power regularly — which is a real issue in the hills and the outer metro — a battery backup unit is worth more than the insurance excess.

Can you make my existing garage door work with my phone?

Usually, yes. Most motors from the last decade or so accept a smart controller, and where yours does not there are add-on modules that work independently of the motor brand. We fit and configure them, show you how the app and any sharing features work, and make sure the safety beams are correctly aligned first — remote and app operation is exactly when a door needs its auto-reverse working properly, because nobody is standing there watching it.
Call Now — Free Quote